How to wire MG4 traffic recorder

The wiring steps for installing a traffic recorder usually include the following key links:

1. Determine the installation position of the driving recorder

Before installing the tachograph, it is necessary to determine its installation position. Generally speaking, the installation position of the tachograph should be in the interior of the vehicle, such as near the inner rearview mirror, in order to facilitate wiring and viewing.

2. Clean the car glass

Before installing the tachograph, it is necessary to clean the car glass to ensure that the light sensor is not blocked.

3. Insert the power cable

Plug the power cord into the ceiling gap, which most cars can easily plug in. Then thread the wire through the interior panel and the rubber strip of the door frame and insert the power cord into the cigarette lighter. If the power cable is too long, use tape to secure it under the glove box.

4. Avoid bumping the pipes on the seat slide rail

During installation, care should be taken to avoid bumping the lines on the seat slide, as this may cause the lines to break. It can be hidden and fixed by using the gap of the car, which is both beautiful and safe.

5. Check the location of the dashcam

After wiring, you need to check and make sure that the tachograph screen is located on the front third of the vehicle, so that you can see the front and the left and right sides of the vehicle at the same time.

6. Dispose of redundant power cables

If there is an excess power cord, it can be stuffed into the ceiling gap, or bundled and taped under the glove box to keep the car clean.

7. Precautions

When wiring, care should be taken not to hit the line on the slide rail of the seat, so as not to break the line. At the same time, the line should be hidden in the gap in the car as far as possible to avoid the line being exposed.

8. Check after completion

After the wiring is completed, the Angle of the tachograph should be adjusted to ensure that the front of the car is 1/3 of the lower part of the picture, and at the same time, the front of the car and the left and right sides can be clearly seen.

If you are not familiar with electrical systems, it is recommended that you should be guided or operated by a professional when making any electrical modifications to ensure safety and compliance with relevant regulations.

Or you can consult MGTITAN for any questions about MG4 car parts and repairs, etc. We are happy to provide effective help, specializing in creating the ultimate user experience platform because of our professionalism.